Always submerge the blender head fully before turning it on.
- Use a tall, narrow container and fill it no more than halfway.
- Start on low speed and pulse in short bursts to control splatter.
- Tilt the blender slightly to create a vortex and keep the blade below the surface.
Why does an immersion blender splatter?
Splattering happens when the blade is too close to the surface. Air gets pulled in and creates bubbles that burst. Starting the blender above the liquid is a common mistake. A wide, shallow container also increases splatter. The blade's high speed can fling liquid outward if not fully submerged. According to the listing, most models work best when the blade is at least an inch below the surface.
How to fix splattering immediately
Turn off the blender and push the head deeper into the liquid. Make sure the blade is fully covered. Restart on the lowest speed setting. Keep the blender head below the surface while it runs. Tilt the blender at a slight angle to help create a vortex. Pulse in short bursts instead of running continuously. This gives you control and reduces mess.
How to prevent splattering in the future
Use a tall, narrow container, like a mixing cup or a stockpot. Fill it only halfway to leave room for movement. Submerge the blender head completely before turning it on. Start at low speed, then gradually increase. Keep the blender moving in a slow, circular motion. This helps blend evenly without splashing. For hot liquids, use a deep pot and a towel over the top as a guard.
When to replace your immersion blender or call a pro
If splattering persists despite correct technique, check for a damaged blade or worn seal. A bent blade can cause uneven blending and splatter. If the motor sounds strained or overheats, it may be time to replace it. Most immersion blenders last several years with proper care. If the shaft is cracked or the button sticks, stop using it. For electrical issues, consult a professional or contact the manufacturer.